- No Items in Cart.
Cronatron® 625 Copper and Brass Stick Rod Electrode 3/32"
Cronatron® - 625 Copper and Brass Stick Rod Electrode, Flux Coated, 50 to 75 Amps, DCRP Polarity, Easy Arc Control, 3/32" (5 US Pounds)
Welcome. Register now to see your pricing.
Close
Cronatron® - 625 Copper and Brass Stick Rod Electrode, Flux Coated, 50 to 75 Amps, DCRP Polarity, Easy Arc Control, 3/32" (5 US Pounds)
Welds most ferrous and non-ferrous metals and joins most combinations of dissimilar metals (except white metals).
Superior Advantages
Tough, crack-free, machinable welds
Easy arc control with little preheat
High frictional wear resistance
High strength
Tensile Strength: 110,000 PSIHardness: Rc 21-23Polarity: DC Reverse
Typical Applications
Brass, bronze or cast iron to steel
Gear teeth, valves and castings
Impellers, cams and shafts
Usage ProcedureUse DC reverse polarity. Clean surfaces of grease, rust or scale. Use short arc with weave or stringer bead. No preheating required, except on heavy sections: 500°F (260°C) steel; 900°F (482°C) copper. For TIG use direct current straight polarity (electrode). Clean surfaces of grease, rust, scale, etc. Use pure argon gas or a mixture of argon/helium for heavy sections. Set the flow rate at 15 to 20 CFH. For best results, use a gas lens collet body. Amperage will depend on ba
Welds most ferrous and non-ferrous metals and joins most combinations of dissimilar metals (except white metals).
Superior Advantages
Tough, crack-free, machinable welds
Easy arc control with little preheat
High frictional wear resistance
High strength
Tensile Strength: 110,000 PSIHardness: Rc 21-23Polarity: DC Reverse
Typical Applications
Brass, bronze or cast iron to steel
Gear teeth, valves and castings
Impellers, cams and shafts
Usage ProcedureUse DC reverse polarity. Clean surfaces of grease, rust or scale. Use short arc with weave or stringer bead. No preheating required, except on heavy sections: 500°F (260°C) steel; 900°F (482°C) copper. For TIG use direct current straight polarity (electrode). Clean surfaces of grease, rust, scale, etc. Use pure argon gas or a mixture of argon/helium for heavy sections. Set the flow rate at 15 to 20 CFH. For best results, use a gas lens collet body. Amperage will depend on ba
† May Require Additional Delivery Time to Canada